For strip bending, set the top switch to the left (for bending) and the bottom switch to the right (fixed cutting)
<Pic>
Remove all protective film from the material
<Pic>
Slide your material sheet under the yellow heating element guard, from the front.
<Pic>
Use the red ruler guide to butt up to for positioning
<Pic>
You can check the material state from a cut out slot in the heater element guard
<Pic>
Heat the material until the part to be bent is flexible
<Pic>
Take the material out from the front when ready
<Pic>
Using a heat resistant mat and jig, or by hand, fold the material to the required angle
<Pic>
Allow the material to cool fully
<Pic>